Description

The B1500 RF amplifier Backpanel Unit is designed to sit between a LDMOS RF amplifier and the rest of your shack. It handles RX/TX switching, antenna selection and transceiver interfacing. It also has a clean, high-efficiency DC-DC converter that supplies 12V at a maximum of 3A for all the amplifier additional circuitry, display, relays and fans. It will run on any voltage from 15V to 55V.

The B1500 is designed to be used with RF power amplifiers up to 1500W and offers minimal insertion loss and mismatch up to 72Mhz. It can also be used on the 2m band with a minor hit in performance: 0.6dB total insertion loss and SWR below 1.3:1.

This is an Advanced level kit and assumes you have a good understanding of electronics. The PCB is supplied with the surface-mount components already installed, but some of the parts supplied in this kit will require assembly and soldering.

The Control Port is designed to connect to a central unit that handles amplifier control and protection. It routes signals from the external AUX port and also includes control lines for antenna selection and input & output switching relays. All signals are in the 0-5V range and can be easily interfaced with a microcontroller of your choice (eg: Arduino). The signals are described in the provided Assembly Instructions.

Additional information

Weight	0.3 kg

Specifications

0.2dB total insertion loss up to 72Mhz, less than 0.6dB at 150Mhz
RF power handing: 100W input max., 1500W output max.
2 selectable antenna ports
DC-DC converter: 15V to 55V input, 12V @ 3Aoutput, 90% efficiency, low noise
AUX port compatible with Elecraft KPA1500 standard & wiring
Control Port compatible with 5V logic
Size: 120x100mm

Kit contents

120*100mm PCB board with installed SMD parts
All additional parts that need to be installed
Connectors
Bolts, nuts, washers, spacers for panel mount
Assembly instructions

Resources

Reviews

There are no reviews yet.

Be the first to review “B1500 RF amplifier Backpanel Unit kit”